中文

News

"Technical Code for Blasting Vibration Monitoring" (T/CSEB 0008-2019)

Zhongke Instruments · News2020-01-12 10:14:12

Home/News/"Technical Code for Blasting Vibration Monitoring" (T/CSEB 0008-2019)
Content

1 Scope

This standard specifies the basic principles, monitoring design, field monitoring, data processing and analysis, report preparation, instrument requirements, and instrument calibration of blasting vibration monitoring.

This standard applies to third-party vibration monitoring of various civil blasting projects; other vibration monitoring work may refer to it.

2 Normative References

The following documents are indispensable for the application of this document. For dated references, only the dated version applies to this document. For undated references, the latest version (including all amendments) applies to this document.

GB 6722 Safety Regulations for Blasting

JJG 676 Verification Regulation of Working Vibration Meters

3 Terms and Definitions

The following terms and definitions apply to this document.

3.1 Blast vibration

The process in which the propagation medium moves back and forth along its equilibrium position in straight or curved lines caused by blasting.

[GB 6722-2014, definition 3.30]

3.2 Blast vibration monitoring

Quantitative monitoring of the vibration impact of blasting operations on the surrounding environment.

3.3 Effect of blasting vibration

The sum of vibration phenomena in the surrounding medium caused by part of the explosive energy propagating outward as vibration waves.

3.4 Particle vibration velocity

The velocity of the reciprocating motion of medium particles under the blasting vibration wave.

3.5 Particle vibration acceleration

The rate of change of the reciprocating velocity of medium particles over time caused by the blasting vibration wave.

3.6 Main vibration frequency

The frequency of the wave corresponding to the maximum amplitude of the medium particles.

T/CSEB 0008—2019

[GB 6722-2014, definition 3.33]

3.7 Duration of vibration

The time elapsed from the arrival of the blasting vibration wave until the signal amplitude decays to less than or equal to 1/e of its maximum peak.

Note: e is the natural constant.

3.8 Scaled distance

The ratio of the distance from the monitoring point to the blast source center and the cube root of the charge per delay.

3.9 Remote vibration measurement system

A blasting vibration test system that promptly uploads field-measured data remotely and analyzes and processes the data.

3.10 Peak particle velocity

The larger of the absolute values of the positive and negative peaks of the vibration waveform.

3.11 Remote data processing

Analysis and processing of data collected by vibration instruments via the network.

icon pdf 4"Technical Code for Blasting Vibration Monitoring" (T_CSEB 0008-2019).pdf